ADK: 31 ! set password $2$JYD3$CcHOBhHYnLzI9O0B9F1Ov/ set enablepass $2$93UN$/2fd2eCwlRdUSkklJ/KZ21 ! #system set system name 6506-01 set system location Core-MDF-10 set system contact sysadmin@corp.com ! #! #vtp set vtp domain Core-Domain set vlan 1 name default type ethernet mtu 1500 said 100001 state active set vlan 10 name Aggregation-10.10.0.0/16-Even type ethernet mtu 1500 said 100010 state active set vlan 15 name Aggregation-10.10.0.0/16-Odd type ethernet mtu 1500 said 100015 state active set vlan 1002 name fddi-default type fddi mtu 1500 said 101002 state active set vlan 1004 name fddinet-default type fddinet mtu 1500 said 101004 state active stp ieee set vlan 1005 name trnet-default type trbrf mtu 1500 said 101005 state active stp ibm set vlan 1003 name token-ring-default type trcrf mtu 1500 said 101003 state active mode srb aremaxhop 7 stemaxhop 7 backupcrf off ! #ip set interface sc0 1 10.1.1.4/255.255.255.0 10.1.1.255
set ip route 0.0.0.0/0.0.0.0 10.1.1.1 ! #syslog set logging console disable ! #set boot command set boot config-register 0x2102 set boot system flash bootflash:cat6000-supcv.5-4-3.bin ! #port channel set port channel 2/7-8,3/7-8 428 ! # default port status is enable ! ! #module 1 : 2-port 1000BaseX Supervisor ! #module 2 : 8-port 1000BaseX Ethernet set port name 2/7 Cat6506-02 set port name 2/8 Cat6506-02 set trunk 2/7 desirable isl 1-1005 set trunk 2/8 desirable isl 1-1005 set port channel 2/7-8 mode on ! #module 3 : 8-port 1000BaseX Ethernet set port name 3/7 Cat6506-02 set port name 3/8 Cat6506-02 set trunk 3/7 desirable isl 1-1005 set trunk 3/8 desirable isl 1-1005 set port channel 3/7-8 mode on ! #module 4 : 8-port 1000BaseX Ethernet set vlan 15 4/1 ! #module 5 : 8-port 1000BaseX Ethernet set vlan 15 5/1 ! #module 6 : 48-port 10/100BaseTX Ethernet ! #module 15 : 1-port Multilayer Switch Feature Card ! #module 16 empty end 6506-01> (enable) Catalyst 6506-02 配置 6506-02> (enable) show config This command shows non-default configurations only.
精品推荐